Dihifa Designer Radiator & Valve Set

A designer radiator and valve set for a water heating circuit — a tall column or panel radiator with the thermostatic and lockshield valves and fixings to connect it. Steel radiator with the matched valve set; fitted to the wall and plumbed into the circuit by a qualified heating or plumbing engineer, then pressure-tested, bled and balanced. The statement radiator, ready to plumb in. Anchor of the range. Plumbed in by a heating engineer; pressure-tested.

• Type: designer radiator + valve set
• Build: steel column/panel radiator, thermostatic + lockshield valves, fixings
• Install: fitted and plumbed in by a qualified heating/plumbing engineer; pressure-tested, bled and balanced

A home heating kit is a heating appliance/system for indoor installation. A water (hydronic) heating kit — underfloor loops, radiators, manifolds and pump/mixing units — must be installed by a qualified heating or plumbing engineer: pressure-tested and leak-free, properly bled and balanced, connected to a suitable heat source, with the underfloor loops laid and screeded by a competent installer. An electric heating kit — electric radiators, panel and infrared panels, underfloor mats — must be wired through an RCD by a qualified electrician, with underfloor mats laid under the floor finish by a competent installer and never cut or crossed. Check the floor's load and build-up before laying underfloor heating. These are heating appliances, not medical devices. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.