Dihifa Hydronic Underfloor Heating Kit (Room)

A water (hydronic) underfloor heating kit for a room — the pipe loops, clips, edge insulation and a small manifold to run warm-water underfloor heating from the home's heat source. Pipe and manifold sized to the room; the loops laid and screeded by a competent installer and plumbed in by a qualified heating engineer, then pressure-tested, bled and balanced before the floor goes down. The warm-water floor for a room. Installer + heating engineer; pressure-tested.

• Type: hydronic underfloor heating kit (room)
• Build: pipe loops, clips, edge insulation, small manifold
• Install: loops laid and screeded by a competent installer; plumbed by a qualified heating engineer; pressure-tested, bled and balanced

A home heating kit is a heating appliance/system for indoor installation. A water (hydronic) heating kit — underfloor loops, radiators, manifolds and pump/mixing units — must be installed by a qualified heating or plumbing engineer: pressure-tested and leak-free, properly bled and balanced, connected to a suitable heat source, with the underfloor loops laid and screeded by a competent installer. An electric heating kit — electric radiators, panel and infrared panels, underfloor mats — must be wired through an RCD by a qualified electrician, with underfloor mats laid under the floor finish by a competent installer and never cut or crossed. Check the floor's load and build-up before laying underfloor heating. These are heating appliances, not medical devices. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.